View Profile: Adonis - Benelli Motorcycle Forum - Benelli Bike Discussions
Benelli Motorcycle Forum - Benelli Bike Discussions - Powered by vBulletin
Tab Content
  • Adonis's Avatar
    06-14-2019, 11:36 AM
    Adonis replied to a thread TnT_service fuse in TNT
    in that case, you are both right; there must be a problem with my wiring ...
    8 replies | 192 view(s)
  • Adonis's Avatar
    06-13-2019, 12:57 PM
    Adonis replied to a thread TnT_service fuse in TNT
    I don't quite understand the wiring diagram ... shouldn't the safety system prevent the gearbox from operating with the clutch position switch closed...
    8 replies | 192 view(s)
  • Adonis's Avatar
    06-11-2019, 11:52 PM
    Adonis replied to a thread TnT_service fuse in TNT
    If pins 1 and 2 are shorted, the service fuse blows while downshifting from 2nd to 1st gear
    8 replies | 192 view(s)
  • Adonis's Avatar
    06-02-2019, 12:52 PM
    Adonis replied to a thread TnT899_disabling the stepper(?) in TNT
    Tested a second stepper with a 3-4 mm shorter shaft than the original. Now the piston moves slightly downwards when I start the engine and the ECU...
    23 replies | 385 view(s)
  • Adonis's Avatar
    06-02-2019, 02:46 AM
    Adonis replied to a thread TnT899_disabling the stepper(?) in TNT
    that's what I did before taking apart the stepper: bypass screws fully closed, TPS reset, butterflies at 2%. But then idling works with the air from...
    23 replies | 385 view(s)
  • Adonis's Avatar
    06-02-2019, 12:37 AM
    Adonis replied to a thread TnT899_disabling the stepper(?) in TNT
    Mine must have been inoperative for a long period (since the engine was changed, 5 years ago?) because the parts were loose and the housing stop...
    23 replies | 385 view(s)
  • Adonis's Avatar
    06-01-2019, 12:48 AM
    Adonis replied to a thread TnT899_disabling the stepper(?) in TNT
    Ok! I can mount another stepper (needs some adaptation first), to see if it moves down. If so, what fails is the valve (which, according to...
    23 replies | 385 view(s)
  • Adonis's Avatar
    05-31-2019, 10:45 AM
    Adonis replied to a thread TnT899_disabling the stepper(?) in TNT
    the stepper wasn't properly mounted and the piston travel inside the housing was larger, that's why it was out of its guide. Now the shaft moves up,...
    23 replies | 385 view(s)
  • Adonis's Avatar
    05-30-2019, 11:40 PM
    Adonis replied to a thread Tnt 1130 2006 in TNT
    The steppper works properly if it moves up, cutting the minimum air intake, when the engine starts, and moves down, leaving free the air intake...
    8 replies | 348 view(s)
  • Adonis's Avatar
    05-30-2019, 02:34 PM
    Adonis replied to a thread TnT899_disabling the stepper(?) in TNT
    that's far enough to block permanently the minimum air intake (can't see the holes when the piston is out)... Maybe I'm wrong, but I think the valve...
    23 replies | 385 view(s)
  • Adonis's Avatar
    05-30-2019, 01:09 PM
    Adonis replied to a thread TnT899_disabling the stepper(?) in TNT
    mine doesn't turn, it just moves out (of its guide, inside the cylinder); last time I opened the airbox I found it like this, don't know when nor why...
    23 replies | 385 view(s)
  • Adonis's Avatar
    05-30-2019, 11:49 AM
    Adonis replied to a thread TnT899_disabling the stepper(?) in TNT
    mine only moves up, never down, also inside the cylinder, until the piston shaft comes out of the guide and stays at the fully open position :doh:...
    23 replies | 385 view(s)
  • Adonis's Avatar
    05-29-2019, 03:47 PM
    Adonis replied to a thread TnT899_disabling the stepper(?) in TNT
    Can't see nothing intended to stop the piston from coming out of the slot. The stepper should open the minimum air passage, once the engine is...
    23 replies | 385 view(s)
  • Adonis's Avatar
    05-29-2019, 12:54 PM
    I'm having a problem with the IAC valve (continuity and voltage are correct, but the piston comes totaly out of its position, blocking permanently...
    23 replies | 385 view(s)
No More Results
About Adonis

Basic Information

About Adonis
Name:
Adonis Karagkounis
Location:
Spain
Occupation:
Teacher

Statistics


Total Posts
Total Posts
39
Posts Per Day
0.02
General Information
Last Activity
Yesterday 11:34 AM
Join Date
04-05-2014
Referrals
0
Google+