I need for my century racer exentric rear bobbins for use off my paddock stand
Which one do you use?? Or you can advise me?
It seems to me to be simple to make a bobbin that slipped into each end of the axle whenever they were needed.
If I had a TNT near me I could easily confirm. Maybe Sprocket or someone closer to you could have a look at this?
You are looking in the wrong place. I'm just about to go out so I'll pm you a link tomorrow.
Benelli Tornado 900 LE No. 49
Benelli 1130 TNT Titainium
Benelli 1130 TRE-K
Benelli 750 SEI
Benelli 250 2c
Got the Officine ones on mine from Maniac motors. Just the job
here's to another trouble free year of Benelli riding
TNT 899 (2013)
MV F4 1000 (2010)
TNT 899s (sold)
Tornado 1130 (sold)
Aprilia Dorsoduro 750.(sold)
If you start with maybe 100 mm of aluminium round stock that fits snugly, then turn one end to the bobbin shape, you'd have what you need for very little cost.
When you need to use them, simply slip them into place with the bobbin at the appropriate position and you're done. No threads required.
If I knew the axle ID I could knock one up in minutes.
Maybe someone on the forum closer to you with a lathe could do it for you?
Of course, if you needed to adjust the chain while on the stand you'd need to rethink the idea a little, but I'm sure it could be done.
You couldn't remove the wheel either, but there's plenty of times I put the bike on the stand to do other jobs on the bike.
Last edited by Engenia; 02-05-2020 at 04:41 PM.