Hi folks, hope you all had a good Easter? Anyone know if it's possible to buy the circular plastic "tool" that is used to disconnect the fuel pipe connector underneath the tank? Has anyone copied / 3D printed it, or does anyone have a spare that they are willing to sell? Cheers for any pointers.
Fuel pipe connector Disconnecting "tool"
chrisTNT1130
1 - 13 of 13 Posts
Hi folks, hope you all had a good Easter? Anyone know if it's possible to buy the circular plastic "tool" that is used to disconnect the fuel pipe connector underneath the tank? Has anyone copied / 3D printed it, or does anyone have a spare that they are willing to sell? Cheers for any pointers.
Sorry - I should have searched for this topic first! I see that several people have asked this question in the past and one of the satisfactory solutions appears to be: replace the factory (plastic & easy to break) connector with a fast-release fuel connector, which can be disconnected one-handed?
Many thanks Errol 👍🏻
I have found this steinconnector product which seals both sides of the connection which is nice because no spills. Rated to 35bar also.
Not decided yet which one to go with, 6 or 8mm. 6mm would fit easily but I dont know if the flow is then restricted.
Not decided yet which one to go with, 6 or 8mm. 6mm would fit easily but I dont know if the flow is then restricted.
Joined
·
7,679 Posts
Don't use 8 mm or you'll have a right bugger of a job trying to widen the inner diameter of the fuel hose enough to take it.
Use 6mm instead
Use 6mm instead
Joined
·
56 Posts
They're available from Motalia:
Joined
·
56 Posts
And if you break the connector then you can buy the fuel line and connector from AliExpress:
I just found this on AliExpress:
￡26.39 | Fuel delivery hose for Benelli Tornado TNT899 TNT1130 TREK899 TREK1130 Cafe Racer TRE Amazonas / TNT TRE 899 1130
Hi everyone, for people able to print in 3d here is the .STL file transfered in .txt because of STL extension is not supported in forum...
just change reservoir_tool - to be renamed in stl.txt => reservoir_tool.stl
just change reservoir_tool - to be renamed in stl.txt => reservoir_tool.stl
1 - 13 of 13 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
