[michael.w.holzer]

I found a similar looking switch here but without measures its difficult to tell if it would fit.

Would anybody have access to a neutral gear switch from a Triumph Trident 750/900, Trophy 900/1200, Daytona 750/900/1000/1200, Speed Triple 900, Sprint 900, Tiger 900 (carburetor) ?

To measure:

• Length of pin from beginning and end of thread
• Thread diameter

 

[michael.w.holzer]

Above Triumph neutral gear switch will very likely not work but a Ducati 53940201A

• Thread diameter: ~ 7.8mm
• Length of pin from beginning to end of thread until hex socke: 28 mm
• OEM: FMDI (as Benelli)

I'll check and post result

 

[freeatlast]

I have a spare ,if you need one, original Benelli

 

[michael.w.holzer]

I have a spare ,if you need one, original Benelli

Did you see my PM?
To qualify or rule out the much more available Ducati sensor as an alternative, would you mind to measure below?

• Length of pin from beginning to end of thread until hex socket: 28 mm