Benelli Forum banner
1 - 3 of 3 Posts

Registered
Joined
10 Posts
Discussion Starter · #1 ·
Have replaced stepper motor but still same problem - engine idling at 2000 and also when you go through gears does not go below 2000 revs making the bike very hard to live with and drive - any suggestions?
 

Registered
Joined
1,236 Posts
Have replaced stepper motor but still same problem - engine idling at 2000 and also when you go through gears does not go below 2000 revs making the bike very hard to live with and drive - any suggestions?
Hi have you checked that there is a tiny bit of play in the throttle cable ?
Also has the TPS been reset recently?.
And maybe the throttle body has been adjusted in the past to open up the butterflies in the intake . It may have a throttle idle/stop screw you could back off .
All are worth a try .
Hope you sort it soon , nothing worse than a fast idling bike in traffic or on a tight slow turn 馃槺
 

Registered
Joined
10 Posts
Discussion Starter · #3 ·
Hi have you checked that there is a tiny bit of play in the throttle cable ?
Also has the TPS been reset recently?.
And maybe the throttle body has been adjusted in the past to open up the butterflies in the intake . It may have a throttle idle/stop screw you could back off .
All are worth a try .
Hope you sort it soon , nothing worse than a fast idling bike in traffic or on a tight slow turn 馃槺
Hi have you checked that there is a tiny bit of play in the throttle cable ?
Also has the TPS been reset recently?.
And maybe the throttle body has been adjusted in the past to open up the butterflies in the intake . It may have a throttle idle/stop screw you could back off .
All are worth a try .
Hope you sort it soon , nothing worse than a fast idling bike in traffic or on a tight slow turn 馃槺
It was a small leak due to rusted hose clamp that was causing the fast idling - all fixed now and idling about 1500rpm from 1900!
 
1 - 3 of 3 Posts
Top