Benelli Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
just taken delivery of Benelli Imperial 400 and it says there's a tool kit under rear seat .How do you get the seat off
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Thanks for your reply I've been looking at an Indian site couldn't follow the language but I could see the way to do it I'm putting side panniers on so its got to go under the seat thanks
 

·
Registered
Joined
·
17 Posts
I bet it’s bolted on … have a look on YouTube for clues 🤔
Sorry for late reply, only just spotted this post. When I bought mine the dealer handed me the toolkit. To remove the rear seat you have to first remove front seat, then you can gain access to two bolts holding front end of rear seat. You then need to remove four bolts holding rear grab rail and seat will then lift off. However t am pretty sure that there will not be enough space under seat for toolkit. I've attached the workshop manual in PDF, this may help. You should have been given the diagnostic plug adapter as well as the toolkit.
 

Attachments

1 - 5 of 5 Posts
Top