Benelli Forum banner
1 - 1 of 1 Posts

Discussion Starter · #1 ·
I read johnny o`s method of filling coolant, and it also states that the cap should be 25mm not 22mm as early ones. My cap is 25mm at the widest part of the seal, but is tapered towards the hole in radiator and measures 22mm at this point. So as you can see I still dont know if it is correct or not? It is rated at 1.4 bar. any advice anyone ?
Also my fans come on when at 3/4 through the white bit on the gauge (its a RS) well that is when they do come on ! , is this where they normally come on ??
Can any one tell me where I can look at a clear wiring diagram,preferably in english ? the manual diag is terrible.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.