Benelli Forum banner

1 - 4 of 4 Posts
G

·
Discussion Starter · #1 ·
Has anyone fitted a gear indicator to the bike? I have purchased a Datatool version and just wondered if anyone had any fitting tips before I try to fit it.
 
G

·
Discussion Starter · #2 ·
Acumen Gear change indicator

I fitted an Acumen version a few months ago with no problems.

I just followed the supplied fitting instructions and it works fine, although sometimes there is a small delay of 2 or 3 seconds before it displays the correct gear, particularly as low revs.
 
G

·
Discussion Starter · #3 ·
gear indicator

Laurence, thanks for the reply, my datatool version does not have specific instructions for the benelli but does have some for a triumph which I believe is the same as the benelli so I will probably use those for the wiring diagram. Did you remove the screen/dash/fairing etc in order to fit it?
 
G

·
Discussion Starter · #4 ·
Re: gear indicator

Hi Banksie,

Yeah, The lot needs to come off to get into the wiring loom behind the clocks. But it's not too big a job

If it helps, these are the colours of the Bike's wiring for my Acumen fitting.

Power - Green/White
Neutral - White/Violet
Speedo - Dark Blue
Tacho - Orange/Grey
Earth/Ground - Black
 
1 - 4 of 4 Posts
Top