Benelli Forum banner
1 - 3 of 3 Posts
G

·
Discussion Starter · #1 ·
Hi Gnome, this may seem like a stupid question but i,ve just recieved my carbon alternator cover , what i want to know is did you remove the steel cover before fitting the new one?
 
G

·
Discussion Starter · #2 ·
Eve Hector, no I left the steel cover on, all you need to do is remove the 3 screws give a good coating of WD40, gently pull the water hose out of the way and manipulate the carbon cover into place (it does fit - trust me) then put the 3 screws back in place - I put a small stainless washer on each one to protect the carbon - job done . . . 100% better look

.GNOME.
 
1 - 3 of 3 Posts
Top