Benelli Forum banner
1 - 3 of 3 Posts
G

·
Discussion Starter · #2 ·
wheel removal

Once you have the main end bolts out (you only really need to remove one), find a wooden dowel, or you could be a little rough and use a half inch drive 12" long socket extension, and tap the axle out either side, BE CAREFUL, DO NOT LOSE THE SMALL LOCATING PIN FROM EACH END.

Upon reassembly, I find it best for undoing the hex bolts in the future, if you try and have the same amount of recess down to the axle from the shoulder of the alloy eccentric cam when you fit the allen bolts in the ends. I had big trouble undoing these bolts if they were bottomed out to the steel axle.
 
1 - 3 of 3 Posts
Top