Benelli Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Just installed a power commander V in this bike. Have not downloaded new map yet. Bike starts, runs and checks out OK other than the light staying on. Is this an error code that could interfere with loading the map?
 

·
Registered
Joined
·
900 Posts
It might because the ecu might be in limp mode so the power commander may not override it. You need to find out why the light is on. There is another chap on here that has fitted one so hopefully he will be along soon.
 

·
Registered
Joined
·
177 Posts
Howdy.i got check engine also but I played with splicing wires to speed signal wire to tune afr by gear so I expected it.i just left it on.i have Auto tune also now so I can give you values by afr for your maps or at least show U mine to make yours easier to work out.dynojeT Italy will give U some service but USA was useless.i rekn it was a big waste of cash in the end.i think I have a post on it otherwise look at chinelli mods thread I posted May be in there
 
1 - 4 of 4 Posts
Top