Benelli Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I placed a GPS on the bike to test the speedo and at 100 kph on the GPS my speedo was reading 114kph.
I have purchased a Speedo healer to adjust the speed. I have read the reports and it seems to do the job bringing the speedo back to read correct.
The trouble is I can find no referense to where the speedo senser is located. This is where the device fits on the circuit.
Can anyone tell or show me where it is located please.

Chickadee66.
 

·
Senior Member
Joined
·
6,029 Posts
If the 502 follows previous Benelli Tre practice, you'll find the sensor at the rear wheel, centred on the rotor fixing bolts.
 

·
Registered
Joined
·
1,236 Posts
Have a read of this thread about calibration of the Speedo done with the setup on the dash :)
 
1 - 4 of 4 Posts
Top