Benelli Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter · #1 ·
Hi All,

So I have had my 07 1130CR and put about 2500kms on it. My issue is now starting below:

  • I feel like my gear selection is not as smooth as normal
  • Neutral is def even harder to find then before
  • I dont have any adjustment left on my clutch lever (see pic)
  • I FEEL like the clutch is not FULLY engaging when I pull the lever (see pic)

However - my clutch is not at slipping in any gear at all (in the high gears etc etc)

Is there any more adjustment points?
Is my clutch cable stretching out?

Light Automotive tire Motor vehicle Automotive lighting Automotive design
 

·
Registered
Joined
·
34 Posts
Discussion Starter · #4 ·
Yes. There is an adjuster at the clutch thrust bearing. By the sounds of what you are experiencing, the locknut may be loose,

Quite possibly it is about to break. When most wires have broken, the remaining ones tend to stretch.
Do you have any pictures or diagrams of what this may look like and how to adjust?
Also the same goes for a clutch cable replacement?

I did some searching and couldn't find anything specific.
 
1 - 5 of 5 Posts
Top