Benelli Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
498 Posts
Discussion Starter · #1 · (Edited)
The genuine Benelli one is over £100, harris make a good one for around £70.
Does anyone know if the Harris one will fit without scratching the swingarm?
I have a Bike-It one but it wouldnt fit without marking the swingarm.
https://www.harris-performance.com/website/acatalog/Paddock_Stands.html


HARRIS NEW GENERATION STAINLESS STEEL "PRONG TYPE" REAR PADDOCK STAND Price: £58.80 (Excluding VAT at 15%)

Thanks.
 

·
Registered
Joined
·
885 Posts
I've got a non branded one, cheap as chips (think it cost me £15 at bike show) just had to buy the right adaptors for it to fit bobbins, no need to spend loads of dosh, mind you it is a bit close fitting but doesnt hit swingarm though, try one from e-bay and if its no good re-sell it
 

·
Registered
Joined
·
2,625 Posts
I've got a non branded one, cheap as chips (think it cost me £15 at bike show) just had to buy the right adaptors for it to fit bobbins, no need to spend loads of dosh, mind you it is a bit close fitting but doesnt hit swingarm though, try one from e-bay and if its no good re-sell it
ditto :D

cheers,
Ian
 

·
Registered
Joined
·
498 Posts
Discussion Starter · #5 ·
The bike-It one with the cup hooks that I already have will catch and I dont want to scratch the swingarm especially as it is black.
 

·
Registered
Joined
·
1,888 Posts
Ditto for me on the cheap ebay jobbie with a couple of hooks bought separately. Works fine.
 
1 - 6 of 6 Posts
Top