Benelli Forum banner

1 - 3 of 3 Posts
G

·
Discussion Starter · #1 ·
The shop repaired my radiator, but i have the impression it is badly mounted. Or maybe its just me?

The thing is:
near the rear brake fluid reservoir you can see a small hole on the side of the radiator, on the upper part of the side. On the other side of the bike its the same. I was under the impression these holes should be covered, so that the radiator should be mounted a bit higher? Can somebody check if i am being wrong here?

tnx
 
G

·
Discussion Starter · #2 ·
Small Holes!!!

If you are talking about the holes that are on the plastic that surrounds the Radiator I've got them too, but I don't know what they are meant for.
 
G

·
Discussion Starter · #3 ·
Re: Small Holes!!!

The holes are showing on mine as well.

Looking at the shape of the upper cowling, it was meant to fit more snuggly, but it doesn't appear to have worked out that way. I haven't had it off (yet), so don't know why the fit is so sloppy. That said, I doubt if it would make a difference to the cooling efficiency if the fit was any better.

I reckon yours is fitting as well as the factory intended.
 
1 - 3 of 3 Posts
Top