Benelli Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello,

I recently installed an Impact Tech clutch lever on my TNT 135 (2020). This meant disconnecting the 2 connectors from the clutch switch, I figured I could just crimp those 2 ends together and call it good. It all worked for a few starts then started getting the 0850 error. to what I believe is a neutral, clutch position issue.

How do you go about cleanly bypassing that dumb clutch switch error?

Should I reconnect just the switch and then depress the "button" and hide it so it always thinks that the clutch is pulled in?

Thank you in advance!
 
1 - 1 of 1 Posts
Top