Benelli Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
737 Posts
Discussion Starter · #1 ·
It looks like the Tre899k uses a different TPS unit but could someone confirm which way the D sits in relation to the terminals. Mine sits with the flat of the D to the top with terminals at the bottom.
 

·
Registered
Joined
·
8 Posts
It looks like the Tre899k uses a different TPS unit but could someone confirm which way the D sits in relation to the terminals. Mine sits with the flat of the D to the top with terminals at the bottom.
TPS.png

This is from my Trek899 in the 0% position, it is the same in the Trek1130 and Trek 1130 Amazonas (at least from 2012->)

Regards.
 

·
Registered
Joined
·
8 Posts
Do you have the part number of that TPS? I've never seen a Trek or TNT with one like that.
maybe it was a modification of the throttle body shaft?
 

·
Registered
Joined
·
737 Posts
Discussion Starter · #5 ·
There are some numbers but they are very difficult to read. Everything looks original but the flat on the shaft is the other way up but to the turn the shaft around would mean butterfly screws toward the engine. have a Rover (Looks similar) on order will let you know if it fits.
 

·
Registered
Joined
·
737 Posts
Discussion Starter · #6 ·
The Rover TPS fits and appears to work (Although it’s not spring loaded) will let you know how it goes on.
 
1 - 8 of 8 Posts
Top