Benelli Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,087 Posts
It probably is a combination of idle co and lower section of map. What is the tps sitting at at idle? if it anything above zero it is using the map for idle. The co correction and idle correction are just random numbers and don’t mean actual co, you would need a gas analyser to check it. i Had a similar issue on one map so just stick with the other.
 

·
Registered
Joined
·
1,087 Posts
Give it a go. The ideal setup relies on many factors butterfly opening, bypass screws, idle co and a functioning stepper motor, I haven’t found a perfect sequence for this. Was it working ok once? If so has anything changed?
 
1 - 4 of 4 Posts
Top